System F4
KLB CONDUCTIVE EP ESD RX

ESD-conductive, slip-resistant coloured sand epoxy resin coating

Build-up of system

Top sealer KLB-SYSTEM POLYURETHAN PU 484
Top coat KLB-SYSTEM EPOXID EP 99 EL+ and mixed sand KLB-Mischsand 3/1, fully scattered with coloured sand CQS-47xx AS
Conductive layer KLB-SYSTEM EPOXID EP 799 Ableitgrund with copper strip KLB-Kupferband attached underneath
Levelling base layer with KLB-SYSTEM EPOXID EP 50 and mixed sand KLB-Mischsand 3/1, fully scattered with KLB quartz sand
Optional primer KLB-SYSTEM EPOXID EP 50

System description

The coating system F4 provides many properties for industrial areas with special requirements on ESD protection. It is designed to have a slip-resistant surface with grades R10 to R11 and is intended for dry uses.

Typical areas of application are, for example, in electronics and electrical engineering. Up to high loads, it can also be used in commercial or industrial production and storage facilities. As one work step** can be saved, the system is very economical.

Alternative systems: System F2 for a lower slip-resistance, System F3 for alternative requirements on the site transfer resistance VDE 100.

Areas of application

Industry

Special solutions
- ESD coatings

Properties

slightly slip-resistant R9/R10
slip-resistant in R11
conductive (ESD)
glossy
application area – Indoor
structured
rigid
resistant to mechanical load

Compare Floor Designer

Downloads

System information

System information EN

Information système FR

Cleaning recommendation

Cleaning recommendation EN

Recommandations d'entretien FR

Build-up of system – single products used

Each of our coating systems is a combination of perfectly matched products.

KLB-SYSTEM EPOXID EP 50

Solvent-free, non-pigmented, all-purpose 2-component epoxy resin for producing primers and scratch coats as well as mortar and levelling layers.

View the product

KLB-SYSTEM EPOXID EP 99 EL+

Electrically conductive, pigmented 2-component epoxy coating resin for producing RX floors suitable for ESD and EX protection. When used in the system with mixed sand KLB-Mischsand...

View the product

KLB-SYSTEM EPOXID EP 799 Ableitgrund

Low-emission 2-component conductive layer based on an epoxy resin emulsion. System product for producing electrically dissipative floor coverings. When used within the s...

View the product

KLB-SYSTEM POLYURETHAN PU 484

High-quality, non-pigmented and light-resistant 2-component polyurethane resin for use as a top sealer on slip-resistant coloured sand scattered coatings and as a clear resin layer...

View the product

Always at your service with professional advice

If you still have questions about our products or systems – please contact us. We will get in touch with you immediately.

Phone

Our competent KLB team will be happy to provide you with quick and straightforward personal advice on our coating systems.

General enquiries
+49 8223 96 92 0

Order hotline
+49 8223 96 92 222

Hotline for technical enquiries
+49 8223 96 92 333

Sales service
+49 8223 96 92 777

Hotline to our export department
+49 8223 96 92 239

Invitations to tender

Sample tenders for our coating systems.

Making work a little easier: Ausschreiben.de provides you with a large number of prepared tender documents for every project type and requirement.

Get to Ausschreiben.de